7
BEFORE OPERATION
ENERGY SAVE MODE
STOP/CLEAR
key
STOP
CLEAR
Your oven comes set with an “Energy Save” mode. When “Energy Save” mode is on, the microwave display will
show “.0” instead of the time of day. If you do nothing for 3 minutes after the preceding operation, i.e. at the end
of cooking, the power will go off automatically and the display will show “OVEN IN ENERGY SAVE MODE” just
before the oven is in “Energy Save” mode. The energy consumption of the oven will nearly equal zero in the
“Energy Save” mode.
To restore the power, open and then close the door.
“Energy Save” mode will
remain “on” until you set the clock.
To set the energy save mode:
3.
Press the
START/AUTO
MINUTE
key once.
1.
Press the
AUTO START/CLOCK
key once.
The energy save mode
will be set and the display
will show nothing.
2.
Press the
AUTO
START/CLOCK
key again.
The display will show:
The display will show:
x1
x1
Your oven has an “Energy Save” mode.
1.
Plug in the oven. Nothing will appear in the display at this time.
2.
Open the door. The display will flash the message shown opposite.
NOTE:
If the display shows different messages from ENERGY SAVE MODE, the oven may be
set in demo mode. Close the door, see page 34 to cancel the demo mode.
3
. Close the door. The oven display wil show “.0”. If you set the clock “Energy Save” mode
will be off. If you want to keep “Energy Save” mode, go to step 5.
4.
Set the clock, refer to page 8.
5.
Heat the oven using the convection and grill without food for 20 minutes. (For operation, see
NOTES on page 10 and 11).
NOTE:
When you plug the oven in, the auto setting for the interactive display guide is ON. To
assist you in operating your oven, useful information will appear on the display. When you
become familiar with your oven, the guide can be turned off. See pages 24 and 25.
Use the STOP/CLEAR
key to:
1.
Erase a mistake during programming.
2.
Stop the oven temporarily during cooking.
3.
Cancel a programme during cooking, press twice.
x1
AUTO START
CLOCK
AUTO MINUTE
START
AUTO START
CLOCK
NOTE:
When the clock is not set, the “Energy Save” mode will be on.
R-953/963M O/M 16/03/2000 10:50 Page 7
