R-8470
R-8570
If the indicator does not respond to touching a key Pad use the following matrix and place a
jumper wire between the proper pin connections with the cable connector disconnected from the
control unit.
If the indicator responds and oven goes into operation, the key unit was faulty.
If there is no response, replace the control unit.
KEY UNIT
(1) The oven should be plugged in at least five minutes
sensor cooking.
(2) Room temperature should not exceed 35
(3) The unit should not be installed in any area where heart and steam are generated. The unit
should not be installed, for example, next to a conventional surface unit. Refer to the
“INSTALLATION Instruction”.
(4) Exhaust vents are providend on the back of the unit for proper cooling and air flow in the
cavity.To permit adequate ventilation, be sure to install so as not to block these vents.
There should be some space for air
(5) Be sure the exterior of the cooking container and the interior of the oven arer dry. Wipe
off any moisture with a dry cloth or paper towel.
(6) The Sensor works with food at normal storage temperature.For example, chicken pieces
would be at refrigerator temperature and canned soup at room temperature.
(7) Foods weighing less than 3 ounces should be cooked by time and vaiper power.
(8) Avoid using aerosol sprays or cleaning solvents near the oven while using Sensor settings.
The sensor will detect the vapor given of by the spray and turn off
food is propary
cooked.
(9) After 30 minutes it the sensor has not detected the vapor of the food, ERROR will appear
and the oven will shut off. When cooking bacon, the sensor must detect the vapor within
1-l
minutes before ERROR appeares and oven shuts off.
Make sure the oven has been plugged in at least five minutes before checking sensor cook op-
eration. The cabinet should be installed and screws tightened.
(1) Fill approximately 200 milliliters (7.2 oz) of tap water in a 1000 milliliter measuring cup.
(2) Place the container on the
of tray in the oven cavity.
(3) Close the door.
(4) Touch SENSOR COOK pad and number pad 1
the oven is in the sensor cooking
condition and AS-l will appear in the display.
(5) Touch Start pad.The oven will operate for the first 16 seconds, without generating micro-
wave energy.
When the AH sensor is defective (open or short), ERROR will appear in the display after 16
seconds cooling time.
If ERROR appears check sensor wire connections and/or AH sensor.
NOTE: ERROR will appear if the door is opend or STOP/CLEAR pad is touched during first
stage of sensor cooking.
17
Summary of Contents for R-8470
