26
R - 5 1 9 C K
R - 5 3 0 C K
R -530 CW
Pin No.
Signal
I/O
Description
36
VSS
IN
Power source voltage: -5.0V.
The power source voltage to the LSI is input to VSS terminal. Connected to VC.
37-38
V3-V2
IN
Terminal not used.
39-40
V1-V0
IN
Power source voltage input terminal.
Standard voltage for LCD. Connected to GND.
41
VCC
IN
Power source voltage: GND (0V).
The power source voltage to drive the LSI is input to VCC terminal.
42-45
COM4-COM1
OUT
Terminal not used.
46-65
SEG1-SEG20
OUT
Terminal not used.
66-79
P74-P91
OUT
Data output terminal to LCD driver IC3.
80-85
SEG35-SEG40
OUT
Terminal not used.
86
P40
OUT
Terminal not used.
87
P41
IN
Signal similar to AN10.
When either G13 line on key matrix is touched, a corresponding signal will be input into P41.
88
P42
IN
Signal similar to AN10.
When either G12 line on key matrix is touched, a corresponding signal will be input into P42.
89
IRQ0
IN
Signal synchronized with commercial power source frequency.
This is the basic timing for time processing of LSI.
90
AVCC
IN
A/D converter power source voltage.
The power source voltage to drive the A/D converter in the LSI. Connected to GND.
91
AN0
IN
Used for initial balancing of the bridge circuit (absolute humidity sensor). This input is an
analog input terminal from the AH sensor circuit, and connected to the A/D converter built
into the LSI.
92
AN1
IN
AH sensor input.
This input is an analog input terminal from the AH sensor circuit, and connected to the
A/D converter built into the LSI.
93
AN2
IN
To input signal which communicates the door open/close information to LSI.
Door close "H" level signal (0V). Door open "L" level signal (-5V).
94
AN3
IN
Terminal not used.
95-98
AN4-AN7
IN
Terminal to change cooking input according to the Model.
By using the A/D converter contained in the LSI, DC voltage in accordance with the Model
in operation is applied to set up its cooking constant.
99
AN8
IN
Input terminal to judge the model.
The signal will be input into AN8 through one of G1 - G8 lines on key matrix. The LSI will
judge the model by this signal.
100
AN9
IN
Signal similar to AN10.
When either G11 line on key matrix is touched, a corresponding signal will be input into AN9.
16.7 msec.
H : GND
L : -5V
