R-350D
15
1
AN10
IN
Signal coming from touch key.
When either G10 line on key matrix is touched, a corresponding signal out of P10 - P17
will be input into AN10. When no key is touched, the signal is held at "H" level.
2
AN11
IN
Signal similar to AN10.
When either G9 line on key matrix is touched, a corresponding signal will be input into
AN11.
3
AVSS
IN
Connected to VC.
4
P10
OUT
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to AN9, AN10, AN11, P41 and
P42 terminal while one of G8 line keys on key matrix is touched.
5
P11
OUT
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to AN8, AN9, AN10, AN11, P41
and P42 terminal while one of G7 line keys on key matrix is touched.
6
P12
OUT
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to AN9, AN10, AN11, P41 and
P42 terminal while one of G6 line keys on key matrix is touched.
7
P13
OUT
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to AN9, AN10, AN11, P41 and
P42 terminal while one of G5 line keys on key matrix is touched.
8
P14
OUT
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to AN9, AN10, AN11, P41 and
P42 terminal while one of G4 line keys on key matrix is touched.
9
P15
OUT
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to AN9, AN10, AN11, P41 and
P42 terminal while one of G3 line keys on key matrix is touched.
10
P16
OUT
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to AN9, AN10, AN11, P41 and
P42 terminal while one of G2 line keys on key matrix is touched.
11
P17
OUT
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to AN9, AN10, AN11, P41 and
P42 terminal while one of G1 line keys on key matrix is touched.
12
X1
IN
Connected to GND.
13
X2
OUT
Terminal not used.
14
VSS
IN
Power source voltage: -5.0V.
VC voltage of power source circuit input.
15
OSC2
OUT
Internal clock oscillation frequency control output.
Output to control oscillation input of OSC2.
16
OSC1
IN
Internal clock oscillation frequency input setting.
The internal clock frequency is set by inserting the ceramic filter oscillation circuit with
respect to OSC1 terminal.
17
TEST
IN
Connected to VC.
18
RES
IN
Auto clear terminal.
Signal is input to reset the LSI to the initial state when power is applied. Temporarily set
"L" level the moment power is applied, at this time the LSI is reset. Thereafter set at "H"
level.
19
P20
OUT
Signal to sound buzzer (2.0 kHz).
A: key touch sound.
B: Completion sound.
20
P21
OUT
Terminal not used.
21
P22
IN/OUT Terminal not used.
22
P23
OUT
Terminal not used.
LSI(IXA049DR)
The I/O signal of the LSI(IXA049DR) is detailed in the following table.
Pin No.
Signal
I/O
Description
A
B
0.12 sec.
2.4 sec.
H : GND
L : -5V
H : GND
L : -5V
Summary of Contents for R-350D
Page 2: ...R 350D ...
