18
R-300BW
DESCRIPTION OF LSI
LSI(IZA882DR)
The I/O signal of the LSI(IZA882DR) are detailed in the following table.
Pin No.
Signal
I/O
Description
1
RST
IN
Auto clear terminal.
Signal is input to reset the LSI to the initial state when power is applied. Temporarily set
to "L" level the moment power is applied, at this time the LSI is reset. Thereafter set at "H"
level.
2
INT
IN
Signal coming from encoder.
When the encoder is turned, the contacts of encoder make pulse signals. And pulse signals
are input into INT.
3
AVSS
IN
A/D converter power source voltage.
The power source voltage to drive the A/D converter in the LSI. Connected to VC.
4
VREF
IN
Reference voltage input terminal.
A reference voltage is applied to the A/D converter in the LSI.
5
K0
IN
Signal coming from potentiometer.
By inputting DC voltage corresponding to the power level set by the potentiometer, this
input is converted into the power level by the A/D converter built into the LSI.
6
K1
IN
Terminal to change functions according to the model.
Signal in accordance with the model in operation is applied to set up its function.
7
AVDD
IN
A/D converter power source voltage.
The power source voltage to drive the A/D converter in the LSI.
8
NC
No connection terminal.
9
S0
OUT
Digit selection signal.
Signal is input to the anodes of the light-emitting diodes (LD19 - LD24).
10
S1
OUT
Digit selection signal.
Signal is input to the anodes of the light-emitting diodes (LD13 - LD18).
11
S2
OUT
Digit selection signal.
Signal is input to the anodes of the light-emitting diodes (LD7 - LD12).
12
S3
OUT
Digit selection signal.
Signal is input to the anodes of the light-emitting diodes (LD1 - LD6).
13-14
NC
No connection terminal.
15
D0
OUT
Segment data signal.
Signal is input to the cathodes of the light-emitting diodes (LD1, LD7, LD13 and LD19).
16
D1
OUT
Segment data signal.
Signal is input to the cathodes of the light-emitting diodes (LD2, LD8, LD14 and LD20).
17
CNVS
IN
Reference voltage input terminal.
A reference voltage is applied to the A/D converter in the LSI. Connected to VC.
18
VSS
IN
Power source voltage: -5V.
The power source voltage to drive the LSI is input to VSS terminal. Connected to VC.
19
D2
OUT
Segment data signal.
Signal is input to the cathodes of the light-emitting diodes (LD3, LD9, LD15 and LD21).
20
D3
OUT
Segment data signal.
Signal is input to the cathodes of the light-emitting diodes (LD4, LD10, LD16 and LD22).
21
D4
OUT
Segment data signal.
Signal is input to the cathodes of the light-emitting diodes (LD5, LD11, LD17 and LD23).
22
D5
OUT
Segment data signal.
Signal is input to the cathodes of the light-emitting diodes (LD6, LD12, LD18 and LD24).