8
R-244M -
PROCEDURE
LETTER
COMPONENT TEST
E
PROCEDURES TO BE TAKEN WHEN THE FOIL PATTERN ON THE PRINTED WIRING BOARD
(PWB) IS OPEN
TEST PROCEDURES
To protect the electronic circuits, this model is provided with a fine foil pattern added to the input circuit on
the PWB, this foil pattern acts as a fuse. If the foil pattern is open, follow the troubleshooting guide given
below for repair.
Problem: POWER ON, indicator does not light up.
STEPS
OCCURRENCE
CAUSE OR CORRECTION
1
The rated voltage is not applied between Pin
Check supply voltage and oven power cord.
No. 5 of the 3 pin connector (A) and the
common terminal of the relay RY2.
2
Only pattern at "a" is broken.
*Insert jumper wire J1 and solder.
3
Pattern at "a" and "b" are broken.
*Insert the coil RCILF2003YAZZ between "c" and "d".
NOTE: *At the time of making these repairs,
make a visual inspection of the varistor.
Check for burned damage. If any ab-
normal condition is detected, replace
the defective parts.
(J1)
b
c
d
a
5
1
R70
RY2
R1
D71
VRS1
ZD70
RY1
D
SWITCH UNIT TEST
If the display fails to clear when the STOP/CLEAR
key is depressed, first verify the lead wire harness
is making good contact, verify that the stop switch
operates properly; that is the contacts are closed
when the door is closed and open when the door is
open. If the stop switch is good, disconnect the
lead wire harness that connects the switch unit to
the display unit and make sure the stop switch is
closed (either close the door or short the stop
switch connector). Use the Switch unit matrix indi-
cated on the switch unit circuit and place a jumper
wire between the pins that correspond to the
STOP/CLEAR key making momentary contact. If
the display unit responds by clearing with a beep
the switch unit is faulty and must be replaced. If the
display unit does not respond, it is a faulty and must
be replaced. If a specific key does not respond, the
above method may be used (after clearing the
display unit) to determine if the display unit or
switch unit is at fault.
1
2
3
4
SW4
5
6
SW5
SW6
SW7
10sec.
10min.
1min.
COOK
DEFROST
STOP
CLEAR
SW8
SW1
CN - C
CN - C
6Pin HARNESS
SW2
SW3
POWER
WEIGHT
START
AUTO MINUTE
