EN-15
CHAPTER -4: PREPARING THE MACHINE FOR USE
Combined detergents
Combined detergents may include various properties in them. Before using a detergent, please read and follow
the instructions well. Generally, combined detergents produce sufficient results only under certain conditions.
Points to consider when using these types of products:
• Check the specifications of the product whether it is combined or not.
• Check if the detergent used is appropriate for the hardness of the main water supply.
• Read the instructions of the products on the packagings.
• Always put the tablets into the detergent compartment in the detergent dispenser.
• You need to contact the manufacturers and find out about the suitable conditions of use.
• If you use appropriate products, they can ensure savings in salt and/or rinse agent consumption.
• The scope of the warranty for your machine does not cover any complaints caused by the use of these types
of detergents.
Recommended usage:
If you want to obtain better results while using combined detergents, add salt and rinse
agent into your machine and adjust the water hardness setting and the rinse aid setting to the lowest position.
The solubility of the tablet detergents produced by different companies can vary depending on
the temperature and time. Therefore, the use of such detergents in short programmes is not
recommended. It is more suitable to use powder detergents for such programmes.
Warning:
Should any problem, which you have not encountered before arise with the use of this type of
detergents, contact the detergent manufacturers directly.
When you give up using combined detergents
• Fill the salt and rinse agent compartments.
• Adjust the water hardness setting to the highest position and run an empty-wash.
• Adjust the water hardness level.
• Set the suitable rinse agent setting.
Filling with rinse agent and making the setting
To fill the rinse aid compartment, open the rinse-aid compartment cap. Fill the compartment with rinse aid to the
MAX level and then close the cap. Be careful not to overfill the rinse aid compartment and wipe up any spills.
In order to change the rinse aid level, follow the below steps before turning on the machine:
•
Push the programme button and hold it down.
•
Turn on the machine.
•
Hold down the programme button until “rA” disappears from the display. Rinse aid setting follows water
hardness setting.
•
The machine will display the last setting.
•
Set the level by pushing the programme button.
•
Switch off the machine to save the setting.
•
The factory setting is “4”.
If the dishes are not drying properly or are spotted, increase the level. If blue stains form on your dishes, decrease
level.
Level
Brightener Dose
Indicator
1
Rinse-aid not dispensed
r1 is shown on the display.
2
1 dose is dispensed
r2 is shown on the display.
3
2 doses are dispensed
r3 is shown on the display.
4
3 doses are dispensed
r4 is shown on the display.
5
4 doses are dispensed
r5 is shown on the display.
CHAPTER -4: PREPARING THE MACHINE FOR USE
