The installation and repairing procedures should always carried out by the Authorised
Service Agent in order to avoid possible risks. The manufacturer shall not be held liable
for damages that may arise from procedures carried out by unauthorised persons. Repairs
may be carried out by technicians only. If a component has to be replaced, ensure that only
original spare parts are used.
Improper repairs or use of non-original spare parts may cause considerable damage and
put the user at considerable risk.
Contact information for your customer service can be found on the back of this document.
Function-relevant genuine spare parts according to the corresponding Ecodesign order can
be obtained from Customer Service for a period of at least 10 years from the date on which
your appliance was placed on the market within the European Economic Area.
EN - 24
9. TROUBLESHOOTING
TROUBLE
CODE
POSSIBLE FAULT
WHAT TO DO
FF
Water inlet system failure
Make sure the water inlet tap is open and water is flowing.
Separate the inlet hose from the tap and clean the filter of
the hose.
Contact for service if the error continues.
F5
Pressure system failure
Contact for service.
F3
Continuous water input
Close the tap and contact for service.
F2
Inability to discharge water
Water discharge hose and filters may be clogged.
Cancel the program.
If the error continues, contact for service.
F8
Heater error
Contact for service.
F1
Overflow
Unplug the machine and close the tap.
Contact for service.
FE
Faulty electronic card
Contact for service.
F7
Overheating
Contact for service.
F9
Divisor position error
Contact for service.
F6
Faulty heater sensor
Contact for service.
HI
High voltage failure
Contact for service.
LO
Low voltage failure
Contact for service.
