EN - 20
7.1.
Changing a Program
Follow the steps below to change
a program while in operation.
After closing the door, the
new program will resume the
course of the old program.
NOTE:
Open the door slightly at first to
stop a program before it is complete in
order to avoid water spillage.
7.2.
Cancelling a Program
Follow the steps below to cancel a
program while in operation.
Press and hold the Program
Selection button for 3 seconds. '1'
will be shown on the Display
.
When the door of your machine
is opened, the most recently
selected program will show on
the display.
7.3.
Switching the Machine Off
"00" will be shown on the displaywhen a
program is complete. A signal will also
sound 5 times. You can then switch your
machine off using the Power On/Of
f button.
NOTE:
The machine will turn off
automatically after 15 minutes, if no
buttons are pressed.
NOTE:
Do not open the door before a
program has finished.
NOTE:
Leave the door slightly open at
the end of a wash program to speed
up drying.
NOTE:
If the door of the machine
is opened or the power is cut during
operation, the program will continue when
the door is closed or the power returns.
Buzzer Sound Control
To change the buzzer sound level,
follow the below steps:
1. Open the door and press Delay (5)
And Options (6) buttons simultaneously for
3 seconds.
2. When the sound setting is confirmed, the
buzzer gives a long sound and the
machine will
display the last set level, from “S0” to “S3”.
3. To decrease the sound level press the
Delay button (5). To increase the sound
level, press the Options button (6).
4. To save the selected sound level, turn off
the machine.’’S0’’ level means all voices the
are off. Factory setting is “S3”.
Save Power Mode
To activate or deactivate Save Power Mode,
follow the below steps:
1. Open the door and press the Half Load
(4) and Delay (5) buttons simultaneously for
3 seconds.
The water discharge process will start after the
door of the machine is closed and will continue
for 30 seconds. A buzzer will sound 5 times
when a program is cancelled.
Disconnect the plug and turn
off the water tap.
Open the door and press the
Program Selection button to
elect a new program.
