Sharp QT-MP3W, Operation Manual

Page: 24 / 28

15
QT-MP3W
Tape Recording
Recording to a cassette tape (continued)
Recording from the built in microphone
Notes:
Monitoring of the recording is not possible.
Recording from the built-in microphone is not in stereo.
Cassette play and record buttons will automatically release when
the end of the tape has been reached.
Recording from CD
Programmed track recording from CD
Note:
Cassette play and record buttons will automatically release when
the end of tape has been reached.
Enhancing your system
Headphone
Before plugging in or unplugging the headphones, make sure the
volume level is reduced.
Be sure your headphones have a 3.5 mm (1/8") diameter plug and
are between 16 ohms and 50 ohms impedance. The recommend-
ed impedance is 32 ohms.
When headphones are connected, the speakers are disconnected
automatically. Adjust the VOLUME control for desired volume.
1
Set the FUNCTION switch to TAPE.
2
Load a cassette into the cassette compartment.
3
Press the PAUSE button.
4
Press the RECORD button.
5
Press the PAUSE button again to begin recording.
1
Set the FUNCTION switch to CD.
2
Load a blank cassette into the cassette compartment with
the side to be recorded on facing up.
3
Press the PAUSE button.
4
Press the RECORD button.
5
Press the PAUSE button again to begin recording.
6
When press the STOP/EJECT / button during recording,
display will appear, but CD still spinning.
7
To stop the CD spinning, press the CD button.
1
Select the memories track you want to record.
2
After memories the selected track, press the RECORD
button. The recording for memory track will begin until
end.
3
After recording is completed, disc will stop to rotate, but
tape still rotating.
4
Press the STOP/EJECT / button to stop recording.
PAUSE
FUNCTION
OFF ON
• M
IN
MAX •
MIC
RADIO
TAPE (STAND-BY)
CD
STOP/EJECT F.FWD REWIND PLAY RECORD
OP
EN
BAND
• AM
• FM
KHz
1600
1400
1200
1000
800
700
600
530
AM
MHz
108
106
104
102
100
96
92
90
88
FM
P U
SH
/C
LO
SE
VOLUME
TU
NING
X-BASS