Sharp QT-CD700W, Operation Manual

Page: 12 / 14

E-9
Recording to a Cassette Tape
Before recording:
I
When recording important selections, make
a preliminary test to ensure that the desired
material is properly recorded.
I
SHARP is not liable for damage or loss of
your recording arising from malfunction of
this unit.
I
The ALC (Automatic Record Level Control)
circuit automatically controls the level of the
input signal used for recording.
I
The VOLUME controls may be adjusted with
no effect on the recorded signal. (Variable
Sound Monitor)
I
Metal and CrO
2
tapes cannot be used for
recording.
CD RADIO
TAPE (STAND-BY)
PAUSE
STOP/EJECT
STOP
F.FWD
UP/
F.FORWARD
REWIND PLAY
RECORD
PAUSE STOP/EJECT F.FWD REWIND
PLAY RECORD
REPEAT
PLAY/
PAUSE
MIC
DOWN/
F.REVERSE
PROGRAM
POWER FM ST
RANDOM
PLAY/
PAUSE
H
Recording from a CD
1
Set the FUNCTION switch to CD.
2
Load the disc to be recorded.
3
Load a blank cassette into the cassette
compartment with the side to be recorded
on facing toward you.
4
Press the DOWN/ F.REVERSE
4 4
4 4
4
or UP/
F.FORWARD
¢ ¢ ¢ ¢ ¢
button until the desired
track number is displayed.
5
Press the RECORD
¶
button to begin
recording.
To stop recording:
Press the STOP/ EJECT
7
/
0
button.
If the STOP
7
or PLAY/PAUSE
3 8
button is
pressed whilst recording, or if the CD comes to
its end, the tape deck will not stop.
To perform programmed recording:
I
Programme disc and track (refer to page E-6).
I
Press the RECORD
¶
button to begin with
recording.
H
Recording from the radio:
1
Set the FUNCTION switch to FM or AM.
2
Tune in to the station to be recorded.
3
Load a blank cassette into the cassette
compartment with the side to be recorded
on facing toward you.
4
Press the PAUSE
8
button.
5
Press the RECORD
¶
button.
I
If a whistling noise occurs when recording
from an AM station, set the BEAT CUT switch
(at the back of the unit) to A or B, whichever
gives the best reception.
6
Press the PAUSE
8
button again to begin
recording.
To stop recording:
Press the STOP/ EJECT
7
/
0
button.
H
Recording from the built-in
microphone
1
Set the FUNCTION switch to TAPE.
2
Load a cassette into the cassette
compartment.
3
Press the PAUSE
8
button.
4
Press the RECORD
¶
button.
5
Press the PAUSE
8
button again to begin
recording.
Notes:
I
Monitoring of the recording is not possible.
I
Recording from the built-in microphone is not
in stereo.
ENGLISH NEW 9/3/04, 2:41 PM 9