background image

7

E

SAFETY INSTRUCTION

- Do not use the monitor where there is a lot of dust, where 

humidity is high, or where the monitor may come into contact 

with oil or steam. Do not use in an environment where 

there are corrosive gases (sulfur dioxide, hydrogen sulfide, 

nitrogen dioxide, chlorine, ammonia, ozone, etc.). As this 

could lead to fire.

- Ensure that the monitor does not come into contact with 

water or other fluids. Ensure that no objects such as paper 

clips or pins enter the monitor as this could lead to fire or 

electric shock.

- Do not place the monitor on top of unstable objects or in 

unsafe places. Do not allow the monitor to receive strong 

shocks or to strongly vibrate. Causing the monitor to fall or 

topple over may damage it.

- Do not use the monitor near heating equipment or in places 

where there is likelihood of high temperature, as this may 

lead to generation of excessive heat and outbreak of fire.

- Do not use the monitor in places where it may be exposed to 

direct sunlight. Risk of cabinet deformation and failure if the 

monitor is used in direct sunlight.

- Please be sure to constantly remove dust and garbage that 

has attached to the ventilation opening. If dust collects in the 

ventilation opening or the inside of the monitor, it may lead to 

excessive heat, outbreak of fire, or malfunction. 

Please request a cleaning of the inside of the monitor from 

an authorized SHARP servicing dealer or service center.

- The power outlet shall be installed near the equipment and 

shall be easily accessible.

- Continuous operating time and warranty. 

This product is designed for a maximum daily use of 16 

hours. Continual use in excess of 16 hours per day is not 

covered by the warranty.

- Do not operate the screen with a hard or pointed object such 

as a fingernail or pencil.

The Power Cord

- Use only the power cord supplied with the monitor.
- Do not damage the power cord nor place heavy objects on 

it, stretch it or over bend it. Also, do not add extension cords. 

Damage to the cord may result in fire or electric shock.

- Do not use the power cord with a power tap. 

Adding an extension cord may lead to fire as a result of 

overheating.

- Do not remove or insert the power plug with wet hands. 

Doing so could result in electric shock.

- Unplug the power cord if it is not used for a long time.
- Do not attempt to repair the power cord if it is broken 

or malfunctioning. Refer the servicing to the service 

representative.

Wireless LAN

- This monitor cannot be used in other than the country or 

region where you purchased it.

- The channels and frequencies that can be used for wireless 

LAN vary by country and region.

 21.   Do not stay in contact with the parts of the product that become hot for long periods of time. Doing so may result in  

low-temperature burns.

22. Do not modify this product.

WARNING:

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may 

be required to take adequate measures.

An apparatus with CLASS I construction shall be connected to a MAIN socket outlet with a protective earthing connection.

STABILITY HAZARD

If a monitor is not positioned in a sufficiently stable location, it can be potentially hazardous due to falling. Many injuries, 

particularly to children, can be avoided by taking simple precautions such as:

• Using fixing devices like wall mount brackets recommended by the manufacturer.

• Only using furniture that can safely support the monitor.

• Ensuring the monitor is not overhanging the edge of the supporting furniture.

• Not placing the monitor on tall furniture (for example, cupboards or bookcases) without anchoring both the furniture and the 

monitor to a suitable support.

• Not standing the monitors on cloth or other materials placed between the monitor and supporting furniture.

• Educating children about the dangers of climbing on furniture to reach the monitor or its controls. 

• This equipment is not suitable for use in locations where children are likely to be present unsupervised.

Especially for child safety

- Don’t allow children to climb on or play with the monitor.

- Don’t place the monitor on furniture that can easily be used as steps, such as a chest of drawers.

- Remember that children can become excited while watching a program, especially on a “larger than life” monitor. Care 

should be taken to place or install the monitor where it cannot be pushed, pulled over, or knocked down.

- Care should be taken to route all cords and cables connected to the monitor so that they cannot be pulled or grabbed by 

curious children.

Summary of Contents for PN-C751H

















Reviews: