Sharp Plasmacluster KC-6400E, Operation Manual

Page: 14 / 100

Be sure to remove the power plug from the wall outlet.
PREPARATION
Pour water into the Tank
This product can be used as an air purifier
without putting water in the tank.
2
1
3
Hold the tank handle and remove the tank.
Remove the tank cap and pour water.
• Use drinkable tap water.
(Generally speaking, tap water is sterilized with chlo-
rine to suppress propagation of bacteria.)
• Change the tank water every day with fresh tap water.
After supplying water, securely tighten the
tank cap.
• Check to see that there is no water leak.
• Be sure to wipe off any excess water around the tank.
• When carrying the tank, hold it with both hands so
that the tank opening is facing up.
Mount the tank to the main unit.
• Insert the tank cap into the dented part of the unit.
• Make sure the tank is firmly attached by pushing it
in until you hear a click.
4
CAUTION
• Do not expose the unit to water. Short circuit and/or electrical shock may occur as a result.
• Do not use hot water (of 40 ˚ C or higher), chemical agents, aromatic substances, dirty water,
etc. Deformation and/or malfunction may occur as a result.
• Do not use mineral water, ionized alkaline water, well water, purified water, etc. Propagation of
mold fungus and bacteria may occur as a result.
• Securely tighten the tank cap. If the tank cap is difficult to tighten, loosen the cap one full turn
to properly set the cap to the tank.
Water Supply Indicator Light (red)
Tank Handle
Tank
Tank Cap
Tank
(Ex.) When water runs out during
Automatic Humidify Mode
When the tank is dry and the water in the tray
begins to dry up, the Water Supply Indicator Light
will begin to flash.
Fill the tank with water.
When not operating in Humidify Mode, press the
Humidify Mode Selection Button to turn the mode
OFF; the Water Supply Indicator Light will turn off.
Flashing
E-12