Sharp Plasmacluster AH-AP18Y, Operation Manual

Page: 14 / 36

E-12
The unit will turn off automatically according to your setting.
Timer duration can be set from minimum 0.5 hours (30 minutes) to maximum 12
hours.
Up to 9.5 hours, you can set by 0.5 hours (30 minutes) increments and from 10 to 12
hours, by 1 hour increment.
TIMER OPERATION
TIMER OFF
When the TIMER OFF is set, the temperature
setting is automatically adjusted to prevent
the room from becoming excessively cold
while you sleep. (Auto Sleep function)
• One hour after the timer operation begins,
the temperature setting rises 1°C higher
than the original thermostat setting.
NOTE:
• The Auto Sleep function will not activate
during the FAN ONLY mode.
1
TO CANCEL TIMER TIPS ABOUT TIMER OFF OPERATION
Point the remote control at the signal receiver win-
dow on the unit.
1
Press the TIMER OFF ( ) button and set
time as desired.
• The time setting will change as you to press the
button as follows.
MODE
DISPLAY MODE
FAN 1h
SWING CANCEL
TEMP.
TEMP.
FAN TIMER
Hold the button pressed down for fast setting.
• The orange TIMER lamp ( ) on the unit will
light.
• The unit will generate a beep when it receives
the signal.
• The time setting will count down to show re-
maining time.
DISPLAY MODE
FAN 1h
SWING CANCEL
Example : When you wish to
stop the operation
2.5 hours later.
Press the CANCEL button.
• The orange
TIMER lamp
(
) on the
unit will turn
off.
TO CHANGE TIMER SETTING
Press the TIMER button which you wish to
change, (TIMER OFF or TIMER ON) and
change the time setting.
0.5h 1.0h 1.5h 10h 11h 12h