Sharp PG-M20 Series, Quick Start Reference Sheet

Page: 3 / 5

SmartPanel Projector Driver Application Note Sharp PG-M20x
© 2003 SP Controls Inc. 601 Minnesota Suite 115 San Francisco, CA 94107 help@spcontrols.com
D. Relays
The following table specifies the factory preset
settings for the low-current relays found on the rear
of the
SmartPanel. The Configuration Utility can
be used to customize these settings your installation.
Relay 1 ON Maintained
Relay 2 ON Momentary
Relay 3 OFF Momentary
Selection Momentary; not Binary
E. Other Presets
The following table specifies other default factory settings for this Driver that affect is control of the
Projector.
Power Status Feedback Method Sensor (see note 1)
Control Wiring Option IR-Emitter (see note 2)
Control for the Sharp with this Driver is via both RS-232 and IR/Wired Remote. We recommend wiring for
the Wired Remote but the included IR emitter may also be used.
The following table specifies settings for the Panel’s configurable timers. For more information on the
inactivity shutdown feature and the lockout timer see the
SmartPanel Configuration and Installation
Manual
Lockout Timer 100 seconds (see note 3)
Inactivity Shutdown Disabled
RELAYS
PWR
ON
MAINT.
PWR
ON
MOM.
PWR
OFF
MOM.
1A 1B 3A 3B 2A 2B 4A 4B 6A 6B 5A 5B 7A 7B
SELECTION
(EXT. SWITCHER CTRL)
4 3 2 1
500mA MAX. CURRENT