Sharp LMV Series, Operations & Parts Manual

Page: 40 / 84

36
E. Collet Alignment Screw Replacement:
a. First mark the location of nose piece “B” to its position to quill “A”.
b. Remove set screw “C” located on nose piece. Remove nose piece by
inserting an adjustable spanner in two holes in the bottom of nose piece.
c. Remove set screw “D”, insert a collet in the spindle and adjust set screw
“D”. First, screw it in until it contacts the collet, then back it off
approximately ¼ turn to allow 0.25 mm (0.01”) play.
d. If collet fits properly, replace set screw “D” and replace nose piece. Be
sure to tighten so that the mark made in step “a” line up.
Figure 36