US
28
AV mode
Mode
IMAGE
WIDEVIEW
(See page 38.)
AV-3
C-SYSTEM
DISPLAY
RESET
Selected item
[NORMAL]
Normal horizontal picture orientation
[MIRROR]
Mirror image
➞
To display mirror picture for special uses.
[FULL]
This mode displays the full screen of the video signal
received. (The picture is displayed slightly stretched
vertically.)
[STRETCH]
This mode displays pictures based on the width of the
screen. Bands are present at the top and bottom.
(Aspect ratio is 16:9)
[INPUT]
AV INPUT 3 put in input mode
[OUTPUT]
The current image and sound are output from AV INPUT 3/AV OUT terminal, when
switching to “OUTPUT”.
“FIXED”: The sound level is fixed.
➞
Adjust it from the connected AV device (e.g.
an amplifier)
“VARIABLE”: The sound level is not fixed. (The maximum level is as much as in
the FIXED setting)
* No sound from side speakers
[AUTO]/[N358]/[N443]/[PAL]/[PAL-60]/[PAL-M]/[SECAM]
* The settings are stored per connection terminal (AV-1/2/3). Even if the power to
the unit is cut off, the settings will remain in the memory.
Turns
[ON]
or
[OFF]
the channel indicators which are displayed when changing
channels.
Returning to the factory setting
PC mode
Mode
AUTO SYNC
SIGNAL INFO
Selected item
Using this function, a stable computer screen without flicker in the display can be
obtained.
Press
ENTER
for adjustment.
* Depending on the signal, the AUTO SYNC function may not provide enough
adjustment. In this case, perform fine adjustment manually.
Even if the output setting is the same at the computer side (e.g. XGA), slight
discrepancies may occur in the adjustment of the hardware.
* Canceling the AUTO SYNC function:
Press
ENTER
to cancel the above function, when “Adjusting the image” is being
displayed.
This measures and sets the frequency when the display is used as a computer monitor.
Adjustments to the On-Screen Display
