3
KB-6014LS
KB-6014LK
KB-6014LW
1. Disengage any power going to the unit.
.
Open the drawer and keep it open.
3. Remove the top cover and right side cabinet.
4. Unhook wiring to Auto Drawer Gear
.
5. Remove bottom screw below Auto Drawer Gear
(Fig. G-1)
.
6. Remove the (4) screws holding the auto drawer gear to the bottom cavity angle
(Fig. G-2)
.
7. Disengage (pull) Auto Drawer Gear from rack gear and slide to the right (toward the rear), then turn motor 90
0
and slip
out along rear of drawer
(Fig. G-3)
.
8. Then tilt Auto Gear Motor 0
o
to extract the assembly out. The Auto Drawer Gear is now free.
Installation:
1. Proceed in reverse to reinstall the Auto Drawer Gear taking care that the gear teeth are set into the cavity angle correctly
Fig. G-2
RACK GEAR REMOVAL
1. Follow the Microwave Drawer disassembly as previously stated
.
Open the drawer and keep it open.
3. To discharge the high voltage capacitor, wait for 60 seconds.
4. Remove the Microwave Drawer by following steps 1, , 5, 8, 9 & 10 as
instructed under "DRAWER ASSEMBLY AND CHOKE REMOVAL".
5. Remove the (3) screws holding the Rack Gear to the bottom slide rail
(Fig. G-5)
.
7. Proceed in reverse to reinstall the new Rack Gear.
Fig. G-5
Fig. G-1
Fig. G-3
AUTO DRAWER GEAR REMOVAL/INSTALLATION
(This procedure requires a 14" or greater phillips screwdriver)
Fig. G-4
Bottom cover
Base plate
Bottom cover
Slide to back
turn 90
o
Tilt
20
o
