E-13
General control (continued)
■
Pairing with the Subwoofer
The sound bar and subwoofer will link automat-
ically (wirelessly) when turned on as it is already
pre-linked at the factory.
SW LINK
Rear Subwoofer
If the link cannot be established, please set the
connection by the following method.
1. Turn on subwoofer. Press and hold the SW
LINK button at back of the subwoofer for more
than 3 seconds.
2. Within 3 minutes, turn on sound bar. Then press
and hold the button on sound bar or remote
control for more than 3 seconds to enter subwoof-
er link mode.
●
During pairing process:
On sound bar: indicator green and orange
indicator blink alternately
On subwoofer: indicator blink in blue.
●
When pairing is successful:
On sound bar: indicator green and orange light
up 3 seconds and disappears.
On subwoofer: indicator turns red.
Notes:
●
If a device such as microwave oven, wireless
LAN card, Bluetooth device or any other device
that uses the same 2.4GHz frequency is placed
near the system, some sound interruption may
be heard due to interference.
●
The maximum transmission distance of the
wireless signal between the subwoofer and
sound bar is about 10 metres (32 feet), but may
vary depending on your operating environment.
If a steel-concrete or metallic wall is between
the subwoofer and the sound bar, the system
may not operate at all, because the wireless
signal cannot penetrate metal.
●
Please check that the volume level of the sub-
woofer is set to your preference.
Caution:
●
Keep the subwoofer away from water and
moisture.
●
To get the optimum listening performance,
make sure the area around the sound bar and
subwoofer is clear of any obstacles.
■
Subwoofer level control (subwoofer)
To increase or decrease the Subwoofer level,
select LEVEL + /-.
Notes:
●
When the level is maximum or minimum the
LED indicator blinks 3 times.
■
Volume control
Press the + or – buttons on the sound bar or
remote control to adjust the volume.
Notes:
●
While adjusting the volume, each time the + or
- button is pressed, the status indicator blinks
once.
●
When the volume level reaches its minimum
or maximum level, if + or – button is pressed
again, the status indicator blinks 3 times.
To increase or decrease the volume continu-
ously, press and hold the +/- buttons.
■
Muting (remote control)
If you wish to turn the sound off, press the
button on the remote control. Press the
button
again or press the + or – buttons on the sound bar
or remote control to resume normal listening.
■
Select Equaliser (EQ) effect
Press the EQ button on the remote control repeat-
edly to select between preset equalisers.
NEWS
Magenta LED flashed in 2 seconds
MOVIE
White LED flashed in 2 seconds
MUSIC
Green LED flashed in 2 seconds
GAME
Orange LED flashed in 2 seconds
■
Function selection
Press the
button on the sound bar or remote
control repeatedly to select the desired mode.
LED indicator colour
Function
MAGENTA
In USB mode
BLUE
In Bluetooth mode
WHITE
In HDMI mode
GREEN
In Audio In mode
ORANGE
In Optical mode
