12
Registering an Additional Adapter
4
When registration is completed, the
POWER
indicator on both adapters
will stop blinking and the
PLC
indicator on both adapters will light solidly or
blink. Remove the new adapter from the outlet and plug it into the outlet
where you wish to use it.
• If the
PLC
indicator on the new adapter does not light up and instead the
POWER
indicator blinks in the pattern
2 blinks OFF 2 blinks OFF ...
registration was not successful. Cancel the registration of the adapter as
explained on page 18, and then try registration again.
3
Hold down the
SET
button on the new adapter for about 2 seconds and
then release it (this must be done within 2 minutes of completing Step 2).
• When you release the
SET
button, the
POWER
indicator will blink and
registration will begin. During registration, communication on the network
may stop temporarily. Registration may take up to 30 seconds.
•
Important:
Do not remove either adapter from the outlet while registration
is taking place.
POWER
SET
POWER
all.book Page 12 Thursday, January 24, 2008 8:51 AM
