en-19
en-20
KN-H24VNA
KN-H24VNA
CARE AND CLEANING
continued
Stirring unit
●
Clean after every use.
●
Wash with mild soap or detergent solution
using a soft sponge. Rinse and dry thoroughly.
Push the stopper (square side) until it clicks,
and the stopper (round side) on the opposite
side will come out.
Insert the
attachment shaft
in the stirring unit
attachment hole.
Push the stopper (square side) and the unit will
come free.
Gently open the stirring wings and remove dirt.
Open the clips on each side and remove
the cover. Remove dirt.
Push the stopper (round side) until it clicks.
The opposite side stopper (square) side will
come out, and the unit will be firmly attached.
Dry the unit carefully after cleaning,
and assemble it in reverse order as
it is removed.
❶
❷
❷
❸
❶
Removing the unit
Cleaning tips
How to attach
Stopper (square side)
Align the
match marks.
Attachment
shaft
Stopper
(round side)
Stirring unit
attachment hole
Cover
Clips
Push to lock the unit in place.
Click
After locking the unit
in place, try to pull it
away from the lid to
make sure it does not
move.
Main unit/Control panel/Temperature sensor/Thermo plate/Power cord
Clean when dirty. Wipe with a soft cloth dampened with water only.
*Remove ingrained dirt from the thermo plate lightly with sandpaper (about 600-Grit) and wipe with a soft cloth
dampened with water only.
Stirring wings
TROUBLE SHOOTING
Answer
Problem
Sounds
Display
The appliance
makes sounds
during operation.
The display gets
foggy.
●
The display can become foggy depending on the environment
(room temperature etc.). The fog will go away on its own.
●
Is the gasket in the center of the inner lid installed correctly?
Can you see the engraved "FRONT" on it?
The display doesn't
show how long Keep
Warm has been on.
●
When Keep Warm ends, the display will show the current time
after 12 hours.
The time displayed
during cooking
increases,
decreases suddenly,
or stops for some
time.
●
While [APPROX.] is displayed, the shown time is the estimated cooking time.
A micro computer controls the cooking, so once the remaining time has
been calculated [APPROX.] will disappear.
The settings are
disappeared.
●
You may hear the following sounds during the cooking. It is common.
-The sound that the appliance controls the heating.
-The sound that the stirring unit works.
●
Is the stirring unit attached correctly?
●
Did you press the
START
button at the end?
If you forget to press the
START
button a reminder sound will beep for
3 minutes, after which the settings will be reset.
Time may increase in
some circumstances.
(Estimated cooking time)
(Exact time left)
The time display
vanishes when I
unplug the power
cord.
Regarding the lithium battery
(inside the appliance)
If the time display shows [ ] (blinking) after plugging in the power cord,
the internal battery is empty. Contact the Customer Service for changing the battery.
You cannot change the battery yourself.
(If plugged in, the appliance can be used as usual even if the battery is empty.
However, you will have to set the current time every time you use the Timer)
Purpose of the battery
：
●
Current time will be displayed even if the power cord is not plugged in.
●
and settings will be stored.
If the internal battery is empty
：
●
The time display and stored Timer data will be lost.
*The battery will not run out while the appliance is plugged in, as the
current time display will operate on electricity from the power plug.
The following problems are common and are not signs that the appliance is malfunctioning.
For heavy dirt, soak the stirring unit in water with
mild detergent solution. That will make it easier to
remove the dirt
(Soak the stirring unit without removing the cover)
Remove the stirring unit when cooking a dish which does not require it - this makes cleaning it easy.
(KN-H24VNA).indb 20
2017/02/24 16:03:26
