04/1/28
CX-GD5100V_EN2.fm
23
GX-CD5100W
Tape Recording
■
Recording from the built in microphone
Notes:
●
Do not connect anything to the Mixing Mic socket.
●
Monitoring of the recording is not possible.
●
Recording from the built-in microphone is not in stereo.
■
Mixing recording from microphone and tape
Notes:
●
Place the microphone about 10 - 15 cm (4 - 6") away from the
source.
●
If the howling occurs, lower the volume or move the microphone
as far as possible from the speaker.
●
To record the microphone signals only, load a cassette into the
TAPE 2 cassette compartment, set the FUNCTION to TAPE 2.
Press the
button and then press the TAPE 2
button.
Caution:
When not using the microphone, remove the microphone plug from
the Mixing Mic socket.
■
Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
High speed dubbing:
After step 4 of the above operation, press the HI-SPEED DUBBING
button.
To stop dubbing:
Press the button.
TAPE 1 and TAPE 2 will simultaneously stop.
■
Erasing recorded tapes
1
Load the tape to be erased into the TAPE 2 cassette
compartment with the side to be erased facing towards you.
2
Press the TAPE (1
2) button until "TAPE 1" appears on the
display.
3
Press the
button.
4
Press the TAPE 2 button to erase side A, or the
button on
the main unit to erase side B.
Note:
Make sure that the TAPE 1 is not in use.
Do not connect anything to the Mixing Mic socket.
1
Press the TAPE (1
2) button until TAPE 2 appears on the
display.
2
Load a cassette into the TAPE 2 cassette compartment.
3
Press the
button to choose one side or both sides.
… To record on both sides.
… To record on only one side.
4
Press the
button.
Recording will be paused.
5
Press the button again to begin recording on side A or
button for side B.
1
Connect the microphone plug to the Mixing Mic socket.
2
Press the TAPE 1 function.
3
Load a blank tape into the TAPE 2 cassette compartment.
Insert a pre-recorded cassette into the TAPE 1 cassette
compartment.
4
Press the
button.
5
Press the button of TAPE 1.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a pre-recorded cassette into the TAPE 1 cassette
compartment. Insert a blank tape into the TAPE 2 cassette
compartment.
It is recommended that the recording tape is the same length as
the master tape.
3
Press the TAPE (1
2) button until "TAPE 1"
appears on
the display.
The reverse mode will be set to
"
".
4
Press the
button.
Recording will be paused.
5
Press the TAPE 1 button to start dubbing.
