Sharp FU-800-J, Operation Manual

Page: 18 / 28

Plasmacluster
AUTO OFF
2h OFF
E-16
OPERATION
REMOTE CONTROL OPERATION
• Before using the Remote Control, turn the Main Power Switch
on.
• When you press the POWER ON/OFF Button, a short beep
will sound and operation will start. It automatically goes to
the last operation mode.
• To stop operation, press the POWER ON/OFF Button again.
A long beep will sound and operation will stop.
Plasmacluster Ion Mode Selections
AUTO Plasmacluster Ion
When pressed the unit will switch between
Clean Mode and Ion Control Mode automati-
cally depending on the amount of impurities in
the air detected by the dust and odour sen-
sors.
Clean Mode operation will operate for about 1
minute when the AUTO function is selected.
Ion Control
The unit will constantly operate in Ion Control
Mode. Ion balance is maintained in the room
by increasing the ratio of negative ions.
(Plasmacluster Lamp is green)
Clean
When pressed the unit will con-
stantly operate in Clean Mode.
Clean Mode is effective for reduc-
ing some airborne mold.
(Plasmacluster Lamp is blue)
OFF
The generation of ions will cease
and the Plasmacluster Lamp will go
out.
If the room smells especially moldy, operate the unit in Clean Mode.
Operations available
with Remote Control
• AUTO
• MANUAL
• 2-hour OFF Timer
Plasmacluster Ion Mode Selections
• AUTO Plasmacluster Ion Mode
• Clean Mode
• Ion Control Mode
• OFF
POWER ON/OFF Button
A short beep will signal that
the unit is on and a long beep
means that the unit is off.
AUTO (Fan Level) Button
The fan level switches auto-
matically depending on the
amount of impurities in the air.
MANUAL (Fan Level) But-
ton
The fan level can be switched
between Silent, Medium and
High.
Transmitter
2-hour OFF Timer Button
Pressing this button sets the 2-
hour OFF Timer. Press it again
to cancel the setting.