EN-8
CARE AND MAINTENANCE
Gently remove dust from the back panel, using a vacuum cleaner
attachment or similar tool.
BACK PANEL
(Pre-filter)
To maintain optimum performance of this air purifier, please clean the main unit including the filter periodically.
Be sure to disconnect the power cord from the wall outlet before performing any maintenance.
NOTE
Always be sure to remove the
power plug from the wall outlet.
1. Remove the Back Panel.
2. Remove the Sensor Filter.
3. If it is very dirty, wash it with water and dry it thoroughly.
Sensor filter
Do not apply excessive pressure, when scrubbing the back panel.
Gently remove dust from the sensor,
using a vacuum cleaner attachment or similar tool.
Tag
HEPA Filter
Sensitive dust sensor
Sensor
(Odor / Temperature /
Humidity)
Deodorizing Filter
CAUTION
Gently remove dust from HEPA Filter and Deodorizing Filter with a
vacuum cleaner attachment or similar tool.
Do not wash in water and dry in the sun.
The filters are fragile, be careful not to apply too much force.
Back
Panel
Sensor
Back Panel
CAUTION
FILTERS
SENSORS
How to clean hard to remove dirt
1. Add a small amount of kitchen detergent to water and soak for about
10 minutes.
2. Rinse off the kitchen detergent with clean water.
3. Completely dry the filter in a well-ventilated area.
• HEPA Filter
Apply the maintenance only on the side with the tag.
Do not clean the opposite side; otherwise, the filter will be damaged.
• Deodorizing Filter
The maintenance can be applied to the both sides.
FP-J50_EN.indd 8
2020/08/31 14:28:42
