24
DV-NC65H/S
DV-NC70H
8-4-2. CARES WHEN REASSEMBLING
INSTALLING THE CASSETTE HOUSING
When the cassette housing is installed on the mechanism,
the initial setting is essential condition.
There are two initial setting methods, namely electrical and
mechanical.
1. Electrical initial setting
So as to perform initial setting of mechanism execute the Step
1 of Installation of cassette housing. After ascertaining the
return to the initial setting position install the cassette housing.
(Conditions: When mechanism and Main PWB have been
installed)
8-4-1. DISASSEMBLING THE MECHANISM
1. When removing the mechanism from the set.
Remove the two screws
1
which connecting mechanism
and main frame.
Take out vertically the mechanism with attention to its
edges, so that it does not damage the adjacent parts.
2. Removing the mechanism and cassette housing.
Remove the two screws
2
fixing the cassette housing
to the mechanism, and remove the cassette housing.
Pinch
Drive Cam
Synchro Gear
Master cam
Main Chassis
Drive Lever
The engaging groove on
the drive lever must be
located as shown in the figure.
The hole of the pinch drive cam
must be directed toward
the synchro gear shaft.
8-4. DISASSEMBLY AND REASSEMBLY
Cassette Control
Housing
Mechanism
Chassis
Main PWB
2
1
STATE OF MECHANISM AT THE
P O S I T I O N W H E R E C A S S E T T E
HOUSING WAS INSTALLED
Summary of Contents for DV-NC65H
Page 63: ...63 DV NC65H S DV NC70H M E M O ...
Page 85: ...104 DV NC65H S DV NC70H A B C D E F G H I J 1 2 3 4 5 6 7 8 9 10 TERMINAL PWB SIDE A Symbol ...
Page 91: ...112 DV NC65H S DV NC70H A B C D E F G H I J 1 2 3 4 5 6 7 8 9 10 M E M O ...
Page 112: ...133 DV NC65H S DV NC70H Ref No Part No Description Code Ref No Part No Description Code ...
