Sharp CP-HP707 Operation Manual Download

Page: 4 / 36

XL-HP707

Imp

ortant Ins

truction

IMPORTANT SAFETY INSTRUCTIONS

(continued)

Outdoor Antenna Grounding -

If an outside antenna or cable system

is connected to the product, be sure the antenna or cable system is
grounded so as to provide some protection against voltage surges and
built-up static charges. Article 810 of the National Electrical Code, ANSI/
NFPA 70, provides information with regard to proper grounding of the
mast and supporting structure, grounding of the lead-in wire to an an-
tenna discharge unit, size of grounding conductors, location of antenna-
discharge unit, connection to grounding electrodes, and requirements
for the grounding electrode.

Lightning -

For added protection for this product during a lightning

storm, or when it is left unattended and unused for long periods of
time, unplug it from the wall outlet and disconnect the antenna or cable
system. This will prevent damage to the product due to lightning and
power-line surges.

Power Lines -

An outside antenna system should not be located in the

vicinity of overhead power lines or other electric light or power circuits,
or where it can fall into such power lines or circuits. When installing an
outside antenna system, extreme care should be taken to keep from
touching such power lines or circuits as contact with them might be
fatal.

Overloading -

Do not overload wall outlets, extension cords, or integral

convenience receptacles as this can result in a risk of fire or electric shock.

Object and Liquid Entry -

Never push objects of any kind into this

product through openings as they may touch dangerous voltage points
or short-out parts that could result in a fire or electric shock. Never spill
liquid of any kind on the product.

Servicing -

Do not attempt to service this product yourself as opening

or removing covers may expose you to dangerous voltage or other
hazards. Refer all servicing to qualified service personnel.

Damage Requiring Service -

Unplug this product from the wall outlet

and refer servicing to qualified service personnel under the following
conditions:

When the power-supply cord or plug is damaged,

If liquid has been spilled, or objects have fallen into the product,

If the product has been exposed to rain or water,

If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the op-
erating instructions as an improper adjustment of other controls may
result in damage and will often require extensive work by a qualified
technician to restore the product to its normal operation,

If the product has been dropped or damaged in any way, and

When the product exhibits a distinct change in performance - this
indicates a need for service.

Replacement Parts -

When replacement parts are required, be sure

the service technician has used replacement parts specified by the
manufacturer or have the same characteristics as the original part.
Unauthorized substitutions may result in fire, electric shock, or other
hazards.

Safety Check -

Upon completion of any service or repairs to this prod-

uct, ask the service technician to perform safety checks to determine
that the product is in proper operating condition.

Wall or Ceiling Mounting -

The product should be mounted to a wall

or ceiling only as recommended by the manufacturer.

Heat -

The product should be situated away from heat sources such

as radiators, heat registers, stoves, or other products (including ampli-

ANTENNA LEAD IN WIRE

P OWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)

GROUNDING CONDUCTORS
(NEC SECTION 810-21)