CD-SW200
SERVICE MANUAL
In the interests of user-safety the set should be restored to its
original condition and only parts identical to those specified be
used.
No. S2510CDSW200/
SHARP CORPORATION
CONTENTS
Parts marked with "
" are important for maintaining the safety of the set. Be sure to replace these parts with specified ones for
maintaining the safety and performance of the set.
This document has been published to be used
for after sales service only.
The contents are subject to change without notice.
CHAPTER 1. GENERAL DESCRIPTION
[1] Specifications ................................................. 1-1
[2] Names of parts............................................... 1-2
CHAPTER 2. ADJUSTMENTS
[1] Mechanism
section ........................................ 2-1
[2] Tuner
section ................................................. 2-1
[3] TEST
MODE .................................................. 2-2
[4] CD
SECTION ................................................. 2-4
[5] CD
section...................................................... 2-4
[6] Standard Specification of Stereo System
Error Message Display Contents ................... 2-4
[7] CD Changer mechanism section ................... 2-5
CHAPTER 3. MECHANISM BLOCKS
[1] Caution
on
diassembly................................... 3-1
[2] Removing and reinstalling the main parts
........ 3-4
CHAPTER 4. DIAGRAMS
[1] Block
diagrams............................................... 4-1
CHAPTER 5. CIRCUIT DESCRIPTION
[1] Notes on schematic diagram .........................5-1
[2] Types of transistor and LED ..........................5-1
[3] Waveforms of CD circuit ................................5-2
[4] Voltage...........................................................5-3
CHAPTER 6. CIRCUIT SCHEMATICS AND PARTS
LAYOUT
[1] Schematic
diagram........................................6-1
[2] Wiring side of PWB...................................... 6-11
CHAPTER 7. FLOWCHART
[1] Troubleshooting .............................................7-1
CHAPTER 8. OTHERS
[1] Function table of IC .......................................8-1
[2] FL
Display......................................................8-9
Parts Guide
CD-SW200
MODEL
CD-SW200 Mini Component System consisting of CD-SW200
(main unit) CP-S200 (front speaker) and CP-SW200 (sub-
woofer).
MINI COMPONENT SYSTEM
Summary of Contents for CD-SW200
