CD-MPS700
SERVICE MANUAL
No. XXXXXXXXXXXXX
SHARP CORPORATION
CONTENTS
Parts marked with "
" are important for maintaining the safety of the set. Be sure to replace these parts with specified ones for
maintaining the safety and performance of the set.
This document has been published to be used
for after sales service only.
The contents are subject to change without notice.
CHAPTER 1. GENERAL DESCRIPTION
[1] Specifications ................................................. 1-1
[2] Names
of
parts............................................... 1-2
CHAPTER 2. ADJUSTMENTS
[1] Mechanism
section ........................................ 2-1
[2] Tuner
section ................................................. 2-1
[3] TEST
MODE .................................................. 2-2
[4] CD
section...................................................... 2-4
[5] CD Changer mechanism section ................... 2-5
CHAPTER 3. MECHANISM BLOCKS
[1] Caution
on
diassembly................................... 3-1
[2] Removing and reinstalling the main parts
........ 3-4
CHAPTER 4. DIAGRAMS
[1] Block
diagrams............................................... 4-1
CHAPTER 5. CIRCUIT DESCRIPTION
[1] Notes on schematic diagram.......................... 5-1
[2] Types of transistor and LED........................... 5-1
[3] Waveforms of CD circuit ................................ 5-2
[4] Voltage ........................................................... 5-3
CHAPTER 6. CIRCUIT SCHEMATICS AND PARTS
LAYOUT
[1] Schematic
diagram........................................6-1
[2] Wiring side of PWB...................................... 6-11
CHAPTER 7. FLOWCHART
[1] Troubleshooting .............................................7-1
CHAPTER 8. OTHERS
[1] Function table of IC .......................................8-1
[2] FL
Display....................................................8-10
Parts Guide
MINI COMPONENT SYSTEM
CD-MPS700
MODEL
CD-MPS700 Mini Component System consisting of CD-MPS700
(main unit) and CP-MPS700 (speaker system).
MINI COMPONENT SYSTEM
Summary of Contents for CD-MPS700
