CD-DK2600V
– 12 –
How to remove the pickup (See Fig. 12-2)
1. Remove the stop washer (B1) x 1 pc., to remove the gear
(B2).
2. Remove the screws (B3) x 2 pcs., to remove the shaft (B4).
3. Remove the pickup.
CD MECHANISM SECTION
Perform steps 1, 2, 3, and 11 to 14 of the disassembly method
to remove the CD mechanism.
How to remove the loading motor
(See Fig. 12-1)
1. Bend the hooks (A1) x 5 pcs., to remove the loading motor.
Figure 12-1
Note
After removing the connector for the optical pickup from the
connector wrap the conductive aluminium foil around the front
end of connector so as to protect the optical pickup from
electrostatic damage.
(A1)x2
(A1)x1
Loading Motor
CD Base
(A1)x2
(B1) x2
ø2.6 x6mm
Shaft
(B2) x1
Stop Washer
(B3) x1
Gear
(B4) x1
CD Mechanism
Pickup
Figure 12-2
TEST MODE
KEY
TEST MODE
CONTENTS
[ON/STAND-BY] [TUNER] + [X-BASS]
TEST 1
TUNER PRESET MEMORY CLEAR
[ON/STAND-BY] [MEMORY/SET] + [X-BASS]
TEST 2
TUNER PRESET FOR PRODUCTION
[ON/STAND-BY] [ ] + [X-BASS]
TEST 3
KEY AND DISPLAY TEST
[ON/STAND-BY] [CD] + [X-BASS]
TEST 4
CD TEST MODE
[ON/STAND-BY] [TAPE] + [X-BASS]
TEST 5
TAPE TEST MODE
[ON/STAND-BY] [ ] + [X-BASS]
TEST 6
ALL CLEAR(RESET)
[ON/STAND-BY] [TUNING/TIME UP ] + [X-BASS]
TEST 7
AUDIO TEST
[ON/STAND-BY] TUNING/TIME DOWN ] + [X-BASS]
TEST 8
PRODUCTION INITIALIZE FOR CHANGER
During POWER OFF mode, push below each 2 keys [ON/STAND-BY] key.
Then go to each TEST MODE.
