4
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity,
(do not remove the waveguide cover)
, and the feature
sticker from the outside of the door, if there is one. Check the unit for any damage, such as a misaligned door,
damaged door seals around the door or dents inside the oven cavity or on the door. If there is any damage,
please do not operate the oven until it has been checked by a SERVICE CENTRE APPROVED BY SHARP
and repaired, if necessary.
2. Accessories provided
1) Turntable 2) Roller stay 3) Operation manual and Cook book
3. Place the roller stay in the coupling on the oven floor, then place the turntable on to the roller stay, ensuring
it is located firmly. Refer to OVEN DIAGRAM below. NEVER operate the oven without the roller stay and
turntable.
4. This oven is designed to be used on a countertop, in a cabinet or built-in. It should not be installed in any area
where excessive heat and steam are generated, for example, next to a conventional oven unit. The oven
should be installed so as not to block ventilation openings.
For R-350L: Allow a space of at least 15cm on the top, 10cm on both sides and 5cm at the rear of the oven
for adequate air circulation. When installing in a cabinet, the minimum inside dimension of the cabinet should
be 720mm(W) x 460mm(H) x 498mm(D).
For R-480L: Allow a space of at least 10.5cm on the top, 10cm on both sides and 5cm at the rear of the oven
for adequate air circulation. When installing in a cabinet, the minimum inside dimension of the cabinet should
be 750mm(W) x 420mm(H) x 496mm(D).
When building the oven into a cabinet or wall, a Sharp built-in kit model number RK-J31S (silver) / RK-J31W
(white) for R-350L and RK-J40W (white) / RK-J40K (black) for R-480L are available which enable the
microwave oven to be integrated within a kitchen, the kit is available from your retailer. Read carefully the
installation instructions for the built- in kit before installation. This built-in kit has been tested according to
Australian Standards. Sharp does not recommend the use of any other built-in kit.
If the oven is to be positioned near a conventional oven, ensure that adequate space is allowed, and a suitable
heat shield is incorporated between the two to prevent damage to the oven and the built-in kit caused by heat.
WARNING: The electrical outlet must be readily accessible so that the unit can be unplugged easily in
an emergency.
5. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or
personal injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase 230 – 240V, 50Hz.
6. This appliance must be earthed.
7. Operate the oven from a general purpose domestic outlet.
If a generator is used, do not operate the oven with non-sinusoidal outputs.
SCA/SCNZ R480L O/M,P01-05
06.12.22, 5:53 PM
4
