List of changes from AR-FN1 to AR-FN1N
No.
AR-FN1
AR-FN1N
Page
Item Content
Change
Remark
1
1-1
[1]-11
Power consumption
Max. 60W
Changed to Max. 70W.
2
2-1
[2]-2
Installation
2. Add the following descriptions to the instal-
lation procedure.
Before installing the AR-FN1:
*
In the case of 2 trays
1. Pull out the paper exit unit from the copier
until it stops.
2. Remove the two screws which are fixing
the paper feed cover. Remove the paper
exit cover.
3. Remove the two transport springs attached
to the paper exitcover.
4. Hang the removed transport springs on the
paper exit unitfront frame (Fig. 1) to keep
there.
5. Return the paper exit cover to the original
position and fixit with two fixing screws.
6. Replace the connection gear at the rear of
the paper exit unitwith the gear packed
together with the unit as shown below.
7. Insert the paper exit unit into the copier.
After completion of the above procedures,
perform installingprocedures according to
the installation manual.
3
2-4
[2]-2-14
Paper exit roller spring removal
14. Delete.
4
3-2
[3]-3
Clutch solenoid
llustration 12: T30RSL
T30RSL is changed to T30RCL.
Table No. 12: T30RSL
5
3-4
[3]-5
Motor PWB unit
Table No.1: Main drive motor
Error print is corrected to
Main drive motor.
6
4-3
[4]-2-A
Table No.(13): Signal name P12CL
Signal name iP12CL is changed to T12CL.
7
4-6
[4]-2-E
Elevator section
Table No.(2): Name elevator drive unit
Corrected to Elevator drive unit.
8
5-1
[5]
Disassembly and assembly
Table Item 2: Part name staple unit drive motor
Corrected to Staple unit drive motor.
[Fig.1]
Paper exit unit
Fixing screw
Paper exit cover
Fixing screw
Transport spring
Connection
gear
AR-FN1N
1/21/1999
– 1 –
