11
BEFORE USING THE MACHINE
1
Loading the bypass tray
1
Unfold the bypass tray.
When feeding large
paper such as B4 and
A3, pull out the bypass
tray extension.
2
Set the paper guides to the copy
paper width.
3
Insert the paper (print face down) all
the way into the bypass tray.
To prevent a misfeed,
verify once more that the
paper guides are
adjusted to the width of
the paper.
Important points when inserting paper in the bypass tray
• Up to 100 sheets of standard copy paper can be set in the bypass tray.
• Be sure to place A6 or A5 size paper or envelopes horizontally as shown in the following diagram (
).
• When loading envelopes, make sure that they are straight and flat and do not have loosely glued construction
flaps (not the closure flap).
• Special papers except SHARP recommended transparency film, labels, and envelopes must be fed one sheet at a
time through the bypass tray.
• When adding paper, first remove any paper remaining in the tray, combine it with the paper to be added and then
reload as a single stack. The paper to be added must be the same size and type as the paper already in the tray.
• Do not use paper that is smaller than the original. This may cause smudges or unclean images.
• Do not use paper that has already been printed on by a laser printer or plain paper fax machine. This may cause
smudges or unclean images.
• If you loaded paper in the bypass tray,
press the [PAPER SELECT] key (
) to
select the bypass tray. The bypass tray will
not be selected automatically.
• If you load thick paper in the bypass tray,
hold down the [TRAY SETTING] key (
)
for more than 5 seconds, use the [PAPER
SELECT] key (
) to select the bypass tray,
and press the [AUTO IMAGE] key
(
). When AUTO IMAGE indicator
(
) lights up, the paper type is set to
thick paper. The setting is cleared when
"Auto clear" works or the [CLEAR ALL] key
(
) is pressed.
Note
AUTO %
AUTO %
Available
Not
available