Sharp AN-52AG2, Operation Manual

Page: 23 / 76

E-9
ENGLISH
1
2
Setting the Angle of the Wall-mount Brackets
Remove the angle holding screws.
Remove the 2 angle holding screws (M5, 8mm length). These 2 screws are used to set the
angle (Step 4). Put the screws in a safe place so as not to lose them.
The wall-mount brackets are preassembled in the vertical (0
°
) position setting when
packed, so the following procedure must be used to install the TV at an angle.
(5 angles are possible: 0
°
, 5
°
, 10
°
, 15
°
, 20
°
)
Open the wall-mount brackets
Loosen the angle setting screws and nuts and then open the wall-mount brackets in the
direction shown by the arrows.
Angle holding screw (black)
Angle setting screw