Sharp 1551 - AL B/W Laser, Operation Manual, Page: 37 / 54

35
6
Copier trouble?
6
COPIER TROUBLE?
This chapter describes misfeed removal and troubleshooting.
MISFEED REMOVAL
When the misfeed ( ) indicator blinks or blinks in the display, the copier will stop because
of a misfeed.
If a misfeed occurs when using the RSPF, a number may appear in the display after a minus
sign. This indicates the number of the originals that must be returned to the document feeder
tray after a misfeed. Return the required number of originals. Then this number will disappear
when copying is resumed or the clear (
) key is pressed.
When the RSPF misfeeds an original sheet, the copier will stop and the RSPF misfeed ( )
indicator will blink, while the misfeed (
) indicator will remain off. For a misfeed of originals in
the RSPF, see “ E Misfeed in the RSPF ” on page 39.
If the copier is turned on with the lower side cover open, the misfeed ( )
indicator will blink. In this case, close the lower side cover. The misfeed ( )
indicator will go out.
1
Ensure that the bypass tray is open and then open the side cover while pressing the
side cover open button.
2
Check the misfeed location. Remove the misfed paper following the instructions for
each location in the illustration below.
If
blinks in the display, proceed to “ A Misfeed in the paper feed area ”. (p. 36)
If paper is misfed here, proceed to “ A
Misfeed in the paper feed area ”. (p. 36)
If paper is misfed here, proceed to “ D Misfeed in the
lower paper feed area ”. (p. 38)
If paper is misfed here, proceed to “ B
Misfeed in the fusing area ”. (p. 36)
If the misfed paper is seen from
this side, proceed to “
C Misfeed
in the transport area ”. (p. 37)