420 774 335 397 www.sharks-shop.cz Stránka 37
Installing or removing depressed center grinding wheel/Multi-disc
WARNING!
•
Always use supplied guard when depressed center grinding wheel/Multi-disc is on tool. Wheel
can shatter during use and guard helps to reduce chances of personal injury..
Mount the inner flange onto the spindle. Fit the wheel/disc on the inner
flange and screw the lock nut onto the spindle.
1. Luck nut
2. Depressed center grinding wheel/Multi-disc
3. Inner flange
To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock
nut wrench and securely tighten clockwise.
To remove the wheel, follow the installation procedure in reverse.
1. Lock nut wrench
2. Shaft lock
Installing or removing flex wheel (optional accessory)
WARNING!
Always use supplied guard when flex wheel is on tool. Wheel can shatter during use and guard helps
to reduce chances of personal injury.
Follow instructions for depressed center grinding wheel/Multi-
disc but also use plastic pad over wheel. See order of assembly
on accessories page in this manual.
1. Lock nut
2. Flex wheel
3. Plastic pad
4. Inner flange
Installing or removing abrasive disc (optional accessory)
Note: Use sander accessories specified in this manual. These must be purchased separately.
Mount the rubber pad onto the spindle. Fit the disc on the rubber pad and
screw the lock nut onto the spindle. To tighten the lock nut, press the
shaft lock firmly so that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise.
To remove the disc, follow the installation procedure in reverse.
1. Lock nut
2. Abrasive disc
3. Rubber pad
OPERATION
WARNING
It should never be necessary to force the tool. The weight of the tool applies adequate pressure.
Forcing and excessive pressure could cause dangerous wheel breakage.
ALWAYS replace wheel if tool is dropped while grinding.
NEVER bang or hit grinding disc or wheel onto work.