420 774 335 397 www.sharks-shop.cz Stránka 22
BATTERY
1. For ADF cartridge use 2 pieces of lithium batteries (CR2032) as a backup power source. Note:
Please recycle used batteries in accordance with local government laws and regulations, the filters
should be recycled in accordance with the electronic processing of waste material.
2 batteries can be used continuously for 5,000 hours in normal condition. If the battery is low hood will
not work correctly.
INSTRUCTIONS FOR TROUBLESHOOTING
Before welding can try your dimmer tape and direct exposure to the front of the cassette bright light
source. Then, using two fingers rapidly cover and uncover the sensors. The cassette should obscure
when the sensor is exposed to light. You can also use a torch lighter.
PROBLEM
CAUSE POSSIBLE
SOLUTION
The outer label is dirty
Clean or replace front skid
plate.
Problematic seen before filter.
Welding filter is dirty
Soap and a soft cloth to clean
the cartridge auto-dimming.
The sensitivity is set too low.
Adjust the sensitivity to the
desired level.
The outer label is dirty.
Clean or replace front skid
plate.
The outer label is flawy.
Check the outer shield
(scratches, pitting), and replace
it if necessary.
Sensors or solar panels are
blocked.
Make sure that the welding not
block sensors or solar panels
with your hand or other
obstructions. Adjust the position
of the welding so that the
sensors can "see" the arc.
Filter the arc to not darken.
Selecting the mode grinding.
Ensure that the correct choice
blackout.
Filter blackout darkens without
igniting the arc.
Sensitivity is set too high.
Adjust the sensitivity to the
desired level.
Filter remains dark after
completion of welding.
The delay time is too long.
Set the delay to the desired
level.
WARNING
ADF is cracked.
If this fault occurs, immediately discontinue use of this device.
Protection from UV/IR radiation may be compromised, which may
result in burning of the eyes or skin.
Part of contention damaged
filter.
Missing, damaged, broken or
twisted front cover plate.
If necessary, replace the front
cover shield.
