420 774 335 397 www.sharks-shop.cz Stránka 24
DESCRIPTION
1 – behind cover
2 – switch
3 – nut
4 – output tie-in
5 – base
SETTING TO WORK
After having read these instructions carefully, you can set your pump to work, reconsidering
the following item:
o
Check if the pump rests on the ground of the shaft.
o
Check of pressure cord has been attached properly.
o
Check if electrical connection is 230 V~, 50Hz.
o
Check if socket is in good condition.
o
Make sure that water and humidity can never come to the mains supply.
o
Avoid pump running dry.
This submersible pump is an approved, maintenance free high quality product, which is
subject to severe final controls.
We recommend, regular inspection and maintenance to ensure long equipment life and
uninterrupted operation.
Important! Note!
o
Remove the mains plug before all maintenance work.
o
In the event that the pump is often transported in the course of operation, it should be
cleaned out with clear water after every use.
o
In case of stationary installation, the function of the loading switch should be checked
every 3 months.
o
All fibrous particles which may have built-up inside the pump housing should be
removed with a water jet.
o
Every 3 months the shaft ground and as should be cleaned from mud.
o
Remove deposits on the floater with clear water.