SKILLER MECH SGK1
6
4.3 Select Lighting Effect
Switch between the six total lighting effects by pressing the SKILLER Function key + F6-F11. The F6, F7 and F9
keys offer two lighting variations. Press the respective key combination twice to cycle through the variations.
Example:
To launch the “Wave” effect, press the SKILLER Function key + F6 once. To launch the “Swirl” vari-
ation, press the SKILLER Function key + F6 twice.
FN + F6:
Wave – The keys light in the form of a wave from left to right, or right to left. Use the SKILLER
Function key + sideways arrow keys to change the direction of the wave.
FN + F6 (twice): Swirl – The lighting rotates around the center of the keyboard. Use the SKILLER Function
key + sideways arrow keys to change the direction of the vortex.
FN + F7:
Tide – Waves run over the keyboard.
FN + F7 (twice): Tide illuminated – The same effect as Tide, but with an activated background illumination.
FN + F8:
Explosion – Starting from the pressed key, the lighting spreads out in a circular pattern
across the keyboard.
FN + F9:
Spiral – Starting from top-right, the keys will light up and run clockwise from outside to inside.
FN + F9 (twice): Grid – Starting from top-right, the keys will light up and run from right to left, then on the
second row from left to right, and then on the third row from right to left, etc.
FN + F10:
Trigger – Every pressed key illuminates and slowly fades.
FN + F11:
Pulsating – All keys will slowly light and dim repeatedly.
FN + F11 (twice): Permanent – All keys continuously illuminate.
4.4 Set Frequency
All lighting effect speeds can be increased or decreased. Press the SKILLER Function key + Page Up to increa-
se the effect speed or SKILLER Function key + Page Down to slow down the effect speed.
Note:
Once the lowest level is reached, the Scroll Lock LED will blink to indicate that a lower level is not possible.
The same will happen once the highest level is reached.
4.5 Lighting Profiles
Your SKILLER MECH SGK1 already includes five preset lighting profiles, which each can be individually custo-
mizable. Within each profile, every key can illuminate with exception to the SKILLER Function key. To custo-
mize a profile, proceed as follows:
• Press the SKILLER Function key + F12. The profile key will start to blink.
• Select the desired profile key (F1 - F5). The lighting will cease.
• Press all keys that should illuminate during this profile. The selected keys will stay illuminated.
• To save the profile, press the SKILLER Function key + F12 again.
The profile is now saved under the selected Function key. To launch the profile, press the SKILLER Function
key and the defined profile key (F1 – F5). To stop the profile, simply select another profile or lighting effect.
Summary of Contents for SKILLER MECH SGK1
Page 1: ...Manual...
