sharkclean .com
sharkclean .com
CHARGING
CHARGING
STORAGE ON THE GO
CHARGING WHILE IN STORAGE MODE
REMOVING THE BATTERY
Charge the unit by placing it on the dock. Make
sure the contacts on the wand are aligned with
the contacts on the charging post.
When charging is complete and you need to
use the unit again, lift it off the dock.
To detach the hand vacuum from the wand, slide
the release buttons on both sides of the handle,
then lift off the hand vacuum.
To reattach the hand vacuum to the wand, align the
nozzle opening over the top of the wand and slide
it on until it clicks into place.
UPRIGHT DOCK CHARGING
HAND VACUUM RELEASE BUTTONS
CONTACTS
For quick and easy short-term
storage, attach the hand vacuum
to the wand by placing it onto the
pre-assembled wand storage clip.
To remove, slide the hand vacuum
up and out. To remove the storage
clip, pull it off the wand.
First, lock the nozzle and wand in
the upright position, and detach
the hand vacuum (see previous
page). Hang the hand vacuum
from the wand storage clip, with
the filter release latch sitting
inside the clip.
To remove the battery from the hand vacuum,
press the release tabs on the battery cap and slide
out the battery. To reinstall, slide the battery
into the compartment in the handle until it clicks
into place.
BATTERY
NOTE:
When the unit is docked properly, the charging
lights on the hand vacuum will blink, indicating that
charging has begun. When charging is complete, all
three indicator lights will remain on for 5 minutes, then
shut off.
NOTE:
The main unit comes with a partial charge.
For maximum runtime, charge fully before first use
(approximately 3.5 hours). Leaving the unit plugged in
will not damage battery life.
