Shark Vancore, Manual

Page: 11 / 16

11
textile PartS
type
The textile and foam parts providing com-
fort to the Vancore make it easy for you
to appreciate the performance of your
helmet to the best. The parts in contact
with the skin are made in a fabric that
is guaranteed to feel pleasant, to absorb
perspiration well and to resist wear satis-
factorily. We treat surfaces to limit the risk
of mould and bacteria.
Always in one concerns of hygiene, the
outer seal are treated against bacteria,
what allows avoiding their proliferation
when we put the helmet.
treatment
Warning! although they are selected
for their quality of resistance and sa-
tisfactory wear, all the interior padding
is subject to normal wear depending
on use and care and maintenance, the
length of use and also the degree of
acidity of your perspiration.
If you note any wear, we advise you to
replace the interior padding in order to
keep your helmet perfectly clean and
comfortable.
Your SHARK supplier can propose you
with replacement parts and also offer
you cheek pads of different thicknesses
and densities, should the standard
selection not correspond to the contours
of your face.
Maintenance
The interior textile parts are washable;
it is important to follow the instruc-
tions below scrupulously to avoid
damaging them.
The cheek pads and head section
must be hand washed in warm, soapy
water (about 30°). Do not use aggres-
sive detergents but either a product
for delicate materials in low dilution or
household soap.
It is essential to dry textile and foam parts
completely before using them. They must
be dried at room temperature. Never iron
textile parts.
For parts with a leather appearance or
textiles attached to safety elements, use a
slightly damp sponge or cloth and house-
hold soap and rinse with clean water.
Avoid allowing too much water to come
into contact with polystyrene parts.
It is essential to ensure that all inte-
rior parts are perfectly dry before using
the helmet.
textile