Shark S640, Safety & Operator Manual, Page: 21 / 21

Take a tape measure, stand vertical along the plate to the gearbox, to measure the height from the gearbox
bottom to the plate side. (Total needed to measure is 9, as there are each 3 screws on one plate. The height
from gearbox bottom to the plate at the side of screws is what we need to measure)
There may be different figures here at the 9 positions. For example
Plate 1: 82mm 85mm 83mm
Plate 2: 83mm 85mm 86mm
Plate 3: 87mm 84mm 88mm
82mm 83mm 85mm 86mm 87mm 88mm
Average for all of these figures is 85mm
So what we need to do is to adjust the others less or more than 85mm to 85mm. (the tolerance is +/- 1mm)
Below are the steps required to adjust the 3
grinding plates to the same horizontal surface.
2 1