Shark S4701 Series, Owner'S Manual

Page: 10 / 24

9 1-800-798-7398
The Shark
®
2-in-1 Blast & Scrub Steam Pocket
®
Mop has Intelligent steam settings that allow you to select the right
amount of steam for your floors and produces greater steam for your accessories. See below for tips on when to use
each setting.
Using Your Steam Mop - continued
SETTING IDEAL FOR THESE SURFACES RECOMMENDED USAGE
Laminate
Hardwood
Marble
Cleaning delicate surfaces
Light cleaning and dusting
Loosening and lifting light dirt
Sanitizing floors
Hardwood
Marble
Tile
Stone
Cleaning most surfaces and large areas
Basic, everyday cleaning
Removing spots and smaller messes
Cleaning moderate- and heavy-traffic areas
Sanitizing floors
Sealed above-floor hard surfaces
around the house
Dusting or cleaning above-floor sealed hard surfaces.
SCRUB BLAST
LO HI
To engage the Scrub Blast Mode, slide the Engage Scrubber/Release Head Button down until
you hear a click. The Stain Scrubber will automatically pop in to position. Lift the Mop body off
the Mop Head and place the Stain Scrubber on the floor to start scrubbing. You can select your
preferred level of steam. Use LO Setting for low-moisture scrubbing. Use the
HI
Setting for
stubborn, stuck-on stains.
TO SANITIZE* WITH THE RECTANGLE MOP HEAD
1
Start with a clean Pocket Pad.
2
Plug in the unit and press the Steam Control Button to select either the
LO
or
HI
Setting.
3
Wait 30 seconds for the unit to begin producing steam.
4
Start mopping on an appropriate sealed hard-floor surface with a forward and backward motion. After three minutes,
your unit is ready to be used to sanitize.
5
Using a forward and backward motion, move the unit over the area you seek to sanitize. Repeat at least 15 times.
* Sanitization studies were conducted under controlled test conditions. Household conditions and results may vary.
With Rectangle Mop Head only. Not with Above-Floor Accessories or in Blast & Scrub mode.