12
TOLL FREE: 1-800-798-7398
Maintenance
Resetting the Motor Thermostat
Your
Shark
®
Navigator
®
Vacuum
is equipped with a protective Motor
Thermostat. If the motor should
overheat, the thermostat shuts off
the power.
To reset the Motor Thermostat:
Move the Power Button to the
“
O
”
– Off
position.
Unplug the vacuum.
Check for clogged hose or filter;
unclog hose and replace filter.
Refer to
Checking for Blockages
on page 11.
Wait 45 minutes for vacuum to cool;
then plug in the vacuum.
Turn the Power Switch to the
“
I
”
– On
position to start the
vacuum.
Note: If vacuum still does not start,
contact Customer Service at:
1-800-798-7398.
Cleaning The Motorized Floor
Brush
When your motorized floor brush
needs cleaning or locks onto an
object, it automatically shuts
down to prevent damage to your
lifetime belt. The indicator light will
illuminate red warning you to turn
off the vacuum and clear blockage
immediately. The light will reset itself
once blockage has been cleared
and power has been cycled on/off
or vacuum has been locked in the
upright position.
1
Detach the motorized floor
brush from the detachable
canister.
2
Inspect the opening underneath
and the rotating brush. If a
build-up of debris is present,
remove it. Carefully cut anything
wound around the rotating
brush with scissors. Avoid
damaging or cutting the bristles.
Rotating
Brush
Ordering Replacement Parts
To order additional parts and accessories,
go to
www.sharkclean.com
or call
1-800-798-7398
.
PART
PART NO.
Super Stretch Hose
152FFJ
Dusting Brush &
Crevice Tool
1115FC
Foam & Felt Filters
XFF80
Hepa Filter
XHF80
Wide Upholstery Tool
261FFJ46
Cleaning Wand
114FFJ
