E
n
g
lis
h
sharkclean .com
sharkclean .com
POWER CORD:
1
Rotate the upper cord clip to quickly
release the power cord.
2
Secure the power cord by wrapping it
around the cord clips
(a)
.
(Fig. 11)
SETTINGS:
= Brushroll On
= Bare Floor
= OFF
3
Press
the selector switch
(b)
to Setting I
to vacuum bare floors (straight suction
only) or to Setting II to engage the
brushroll (for vacuuming carpets and
rugs).
(Fig. 11)
Brushroll Indicator Light:
The brushroll
indicator light
(c)
will illuminate green
when the brushroll is on, or red if there is
a blockage or jam.
(Fig. 11)
This feature
is designed to protect the brushroll. See
Checking for Blockages
on page
19
.
4
To activate the brushroll, step lightly on
the floor nozzle, then tilt the handle back.
(Fig. 12)
NOTE:
The brushroll will not spin unless
the nozzle is flat against the floor and the
handle is tilted back.
5
Increase or decrease suction power by
adjusting the suction release collar
(d)
on the handle.
(Fig. 11)
If the vacuum
seems difficult to push or pull or if it is
lifting up area rugs, reduce suction by
rotating the collar counterclockwise. To
increase suction and to vacuum floors,
rotate the collar clockwise.
6
Empty dust cup after vacuuming and
periodically during use when it appears
full. (See Maintenance section for
instructions.)
7
When you are finished vacuuming, move
the switch to the Off position.
Fig. 12
Fig. 11
Adjust the
suction release
collar to reduce
suction for
easier push
and pull on
thick carpets
and area rugs.
1
Press the Lift-Away button
(b)
, then lift
the canister off the floor nozzle.
(Fig. 13)
2
To clean with the handle, press the
Handle Release button
(a)
and lift the
handle out of the wand. To clean with
longer reach, press the Wand Release
button and lift off the wand.
(Fig. 14)
3
Attach desired accessory onto the end
of either the wand or the handle.
4
Move the selector switch to Setting I
(Bare Floor) for above-floor cleaning.
Lift-Away® Mode
Use the handle on top of the
dust cup to easily lift and
carry the canister.
Fig. 14
Fig. 13
Above-Floor Cleaning
1
Press the handle release button to detach
the handle or press the wand release
button to detach the wand.
2
Attach desired accessory onto the end
of either the wand or the handle.
(Fig. 15)
3
Move the selector switch to Setting I for
above-floor cleaning.
Adjust the suction
release collar to
reduce suction for
easier push and pull
on thick carpets
and area rugs.
Fig. 15
Suction
Release Collar
c
Upper
Cord
Hook
Suction
Release Collar
d
a
b
a
a
b
