10
11
Your Shark
®
Lift-Away
™
Pro Steam Pocket
®
Mop is designed to clean surfaces that
will withstand high heat and moisture.
Do not use on unsealed wood surfaces
(especially wooden antique furniture),
unglazed ceramic tile, painted surfaces
or surfaces that have been treated with
wax, oils, varnishes, or shellac. The sheen
may be removed by the heat, steam, and
friction of the cleaning tools. Lacquer and
polyurethane coatings provide a hard
durable protective finish that withstands
moisture, but it is always recommended to
test an isolated area of the surface to be
cleaned before proceeding.
We also recommend you check the use
and care instructions from the surface
manufacturer.
When cleaning finished wood surfaces,
use broad, continuous cleaning strokes. To
prevent surface damage, avoid focusing
steam or allowing the cleaning tools to sit
in one spot for any amount of time.
Getting Started With Your
Removable Handheld Steamer
1
To remove the Handheld Steamer, press and
hold down the Handheld Release Buttons while
pulling out the Handheld Steamer. (
fig. 15
)
fig. 15
Cleaning Tip: The Direct Steam Nozzle creates direct steam spray to clean and sanitise
hard to reach nooks & crannies and other places where germs may build up. Use the
Direct Steam Nozzle to loosen and dislodge compact dirt often found in corner and tight
places where traditional methods and cleaning tools tend to push dirt into, making it
tough to reach and clean. Spray direct steam and wipe clean with a wet cloth or paper
towel.
Using Your Removable Handheld Steamer
with Direct Steam Nozzle
CAUTION:
Do not press the steam trigger until
the Direct Steam Nozzle is snapped into the main
nozzle of your Handheld Steamer.
4
To remove the Direct Steam Nozzle, press and
hold down the Handheld Release Buttons. Then
slide out the Direct Steam Nozzle using the grip.
CAUTION:
Do not press the steam trigger
while removing the Direct Steam Nozzle. Avoid
touching the tip of the Direct Steam Nozzle, as
this will be very hot after steaming.
NOTE:
The Handheld Steamer may continue to
emit steam for a few seconds after the trigger
is released This is normal, and the steaming will
eventually come to a stop.
FOR SPOT CLEANING AND STEAMING
2
First attach the Direct Steam Nozzle by pressing
the nozzle onto the Handheld Steamer until it
clicks into place. (
fig. 16, fig. 17
)
3
The Handheld Steamer is automatically set to
SCRUB mode. Squeeze the steam trigger to
activate steam. To change modes press the
ON/
STEAM SETTING
button to select either DUST,
MOP or SCRUB mode. You can change the steam
mode while the Handheld Steamer is in standby
or in use. Once the selected setting indicator
light has turned blue, hold down the steam
trigger to start steaming. (
fig. 18
)
For effective cleaning, hold the steam output
nozzle 1-2 inches away from the surface you’re
cleaning.
fig. 17
fig. 18
fig. 16
