AZ1002C_QSG_MP_Mv2
For questions or to register your product, visit us online at sharkclean.com
©2019 SharkNinja Operating LLC. DUOCLEAN, LIFT-AWAY, POWERED LIFT-AWAY, and SHARK are registered
trademarks of SharkNinja Operating LLC. APEX is a trademark of SharkNinja Operating LLC.
QUICK
START
GUIDE
Please be sure to read the enclosed Shark® Owner’s Guide prior to using your vacuum.
Use this Quick Start Guide to
start using your new vacuum’s
great features.
Register your vacuum at
registeryourshark.com
For additional parts and
accessories, visit
sharkaccessories.com
AZ1002C
POWERED LIFT-AWAY
®
Clearing Blockages
1. To open the brushroll garage, slide both
release buttons on the floor nozzle away
from you, toward the back of the nozzle,
then lift off the lid.
2. Clear away any objects or debris.
3. To close the brushroll garage, insert the
3 tabs on top of lid into the 3 slots in the
nozzle, then push down on both sides of
lid until it clicks securely into place. If the
Brushroll Indicator Light isn’t green and
headlights are flashing, check again that
both sides of lid are locked in place.
MAINTENANCE
Empty dust cup after each use
Empty
Release
Brushroll Maintenance
Carefully remove any debris that may be
impeding the brushroll.
Cleaning the Soft Roller
Lift out the Soft Roller by pulling the tab
on the right side. Clear away any debris,
then slide the Soft Roller back into place.
Checking the Nozzle for Blockages
Tilt neck of nozzle back to straighten the
airway, then remove any blockages.
The self-cleaning brushroll delivers nonstop hair removal while you vacuum,
sending it to the dust cup. To clear any blockages, see instructions below.
™
Filter Maintenance
Wash filters regularly to keep
the suction strong.
Rinse filters with water only, and
allow them to air-dry completely
before reinstalling. Tap loose dirt
from foam filters as needed
between washes.
See enclosed Owner’s Guide
for complete details on
removing and cleaning filters.
Self-cleaning brushroll
NOTE:
If you see any hair wrapped around
the brushroll, continue cleaning, using
CARPET/LOW PILE mode on a bare
floor surface.
®
Self-cleaning brushroll
