5
“BOOST” Mandatory Operations:
1)
If with correct connection between Jump Starter and vehicle battery (Red LED
keeps on and green LED is off), press and hold BOOST button for 3 seconds (after a
buzzer sound, the green LED is on and red LED is off). Usually this is because the
vehicle battery capacity is rather low.
2)
Start the engine (same method as the normal operations in Page 6).
Cautions:
1)
Under normal circumstances, do not use the mandatory operations.
2)
The spark proof, reverse polarity protection and short circuit protection features
are disabled after Boost button is pressed. Pay very close attention to the polarity
of the battery before using this mode. Do not allow the positive and negative
battery clamps to touch or connect to each other as the item will generate sparks
and high heat if not used properly.
LED and Buzzer Communication:
No.
Red LED
Green LED
Buzzer Sound
Condition
1
On
Off
One sound
Jumper cable and EPS-400
are connected.
2
Off
On
One sound
Jumper cable and vehicle
battery are connected. Ready
to start the engine.
3
Slow
flash
Off
No buzzer
Lithium battery voltage in
EPS-400 is rather low.
4
Slow
flash
Off
No buzzer
Have not turned on the
ignition switch within the
regulated time. To resolve
this, you need remove
clamps from vehicle battery,
and connect again when
No.1 condition occurs.
5
Fast
flash
Off
Fast buzzer
Red and black clamps are
connected with each other.
