13
sharkclean .co.uk
12
sharkclean .co.uk
MAINTENANCE
EMPTYING THE DUST CUP
To remove
Dust Cup
, pull up on the release
button located on the side of dust cup handle�
Tilt dust cup forward, then lift to remove�
To reattach, place the bottom of dust cup
onto the pod and then tilt until it clicks
into place�
Hold the dust cup over the bin and press the
release button to open bottom of dust cup�
To remove collected debris from
Lint Screen
,
lift the tab at the top of the dust cup to
open the lid� Remove debris from lint screen
to clean�
Regularly rinse the filters to maintain your vacuum's suction power.
Rinse filters with cold water only� Allow all filters to air-dry for at least 24 hours before
reinstalling them to prevent liquid from being drawn into electronic parts�
IMPORTANT:
DO NOT
use soap when cleaning the filters�
IMPORTANT:
Unplug the power cord before performing any maintenance�
Post-Motor
Filter
Foam
Felt
Filter
Door
RINSE PRE-MOTOR FILTERS
EVERY MONTH
1
Pre-Motor (foam and felt):
With the dust cup removed, take out the
foam and felt filters, and rinse with water� Tap
loose dirt off filters between washes
as needed�
RINSE POST-MOTOR FILTER EVERY YEAR
To remove the
Post-Motor Filter
, first pull
the tab on the bottom of the filter door, then
lift off the door� Press the tab on the side of
the Post-motor filter�
To reattach the door, align the top first, then
press in the bottom until it clicks into place�
ANTI HAIR WRAP BRUSH-ROLL
If any hair is wrapped around the brush-roll, continue vacuuming using Carpet/Low Pile mode on
a bare floor surface, a low-pile carpet, or a small area rug in MAX suction mode� This will allow
the Anti Hair Wrap brush-roll to remove the hair wrap and send it to the dust cup�
If you run over a hard or sharp object or notice a noise change while vacuuming, check for
blockages or objects caught in the brush-roll�
If some fibres remain wrapped around the brush-roll after continued use, clear them from the
brush-roll�
NOZZLE MAINTENANCE
CLEANING THE FILTERS