Shaper S01-EN, Product Manual

Page: 27 / 84

shapertools.com 19
Safety & Care
Only operate Origin with the SM1 Spindle
provided by Shaper. Use with any other router
spindle will cause damage and may result in a
risk of electric shock.
Do not forcibly move the Z-Axis carriage up
and down. Doing so may cause damage to
Origin’s electronics.
Do not forcibly move the spindle mount from
side to side. Doing so may cause damage to
Origin’s electronics.
Cut at an appropriate depth per pass. Origin can
easily and consistently do multiple passes on
your design at increasing depths. Do not attempt
to cut deeper in one pass than Origin’s movement
stage or spindle can handle. If Origin sounds
like it is audibly struggling, reduce the depth of
your cut, change your material or router bit, or
adjust spindle speed. Visit support.shapertools.
com for recommendations on how to cut various
materials.
Cut at an appropriate feed rate. If Origin’s
correction range is unable to keep up with your
feed rate, move Origin slower, reduce the depth
of cut, change your router bit, and/or adjust the
spindle speed. Visit support.shapertools.com for
recommendations on appropriate feed rates for
various materials.
Use an appropriate router bit for your material.
Different materials cut best with different types of
router bits. Cutting with the wrong type of router
bit can negatively impact cut quality. Do not cut
with dull or damaged router bits. Visit support.
shapertools.com for recommendations on router
bit types to use with various materials.