Step 2
In a convenient
locations, mount the
two #6 screws vertically
3-1/4in apart leaving
the screwheads approx-
imately 1/8in from wall
or mounting surface.
Hand power supply
onto screws.
Step 3
Route the RG-59 cable from the antenna to this
power supply. Allowing enough cable slack for later
installation of F-connectors, cut the cable. Route
the remaining piece of RF-59 from the power supply
to the back of the TV.
Step 5
Conenctor power supply kits. Connect the cable
from the antenna to the power adapter. Connect
the output connector of the power supply unit to the
DTV receivers or TVs. Connect the AC/DC adapter
to the 12V DC jack on the power supply unit and
plug the adapter into the power socket. Adjust the
gain in the power supply unit for best signal recep-
tion. See Figure 4.
Step 4
To install F-connectors strip cable jacket. See
Figure 2A.
Push back and twist the braid around the Dielectric
until it butts against the cable jacket. See Figure 2B.
Screw the F-connector onto the cable jacket until the
Dielectric butts against the inner retaining ring. Cut
the center conductor off flush with the end of the
connector. See Figure 2C.
Repeat this step to install all four type F-connectors.
Special note: Place boot on cable before installing
F-connector at the antenna.
#6 screws
3-1/4in
Connect Female F-Connector to Male F-Connector
Figure 3
Figure 2A
Figure 2B
Figure 2C
Pre-stripped
From Factory
RG/59
Jacket
Type F-Connector
Twist Braid
Dlelectric
Center Conductor
Center Conductor To Be Flush
With End Of Connector
RG/ 59
RG/ 59
½in
¼in
¾in
